How to clean the toilet from rust at home

The content of the article

1 Acid Cleaners
2 Hydrogen peroxide and gelatin
3 Oxalic acid and ammonia
4 Dishwasher Gel
5 "Coca Cola"
6 Hydrochloric acid
7 Car Battery Electrolyte
8 Vinegar
9 Chlorine-containing drugs
10 Soda and tartaric acid
11 Video: how to clean the toilet from plaque and rust

Pipes used in bulk water transportation are made of non-galvanized steel. In the past 10 years, they began to produce polyethylene, but the first option is not going anywhere. The impact of sand and other foreign substances destroys the inner surface of the pipes, and water drives the microparticles further. With prolonged contact of the toilet bowl with running water, these substances are deposited and eaten into the enamel. In a state of neglect, it is difficult to remove rusted neoplasms, but we have compiled a golden collection of effective methods for you.

Acid Cleaners

Before using the acid composition, you must wear high rubber gloves, wide goggles and a disposable respirator.Also, after processing the toilet, you should not be in the toilet room, proceed as follows: put the composition, closed the toilet lid, waited for the required period of time, returned and washed.

In the process of the action of acids on rust, complex compounds are formed that destroy the enamel. Therefore, carefully read the instructions on the back of the bottle, the manufacturer indicates the maximum allowed exposure time.

Consider the popular and well-proven acidic remedies:

"Chistin Sanitary" (Stupinsky chemical plant);
Domestos 100% (pink, green);
"Toilet duck Antirzhavchina";
"Triumph";
"Stork Sanoks Ultra";
"Comet 7 days of cleanliness for the toilet";
"Faberlic Clean Toilet";
"Mole";
"Sarma Gel for plumbing".

The technology of using the composition is quite simple: apply a means of abundant layer to the place of rust or under the entire surface of the bezel, wait 20-30 minutes (the exact time is indicated by the manufacturer on the package). After that, flush and clean the toilet with a brush.

how to clean the urine stone toilet

Hydrogen peroxide and gelatin

Do not confuse peroxide with hydrogen peroxide, they have completely different concentrations. Mix 100 ml.drug with 300 ml. filtered water, add 70 gr. gelatin, wait 15 minutes. At the end of the term, wear gloves, scoop the mixture with a sponge and apply it to the place of rust formation. Leave at 7-10 hours, at this time you can not use the toilet. Also, make sure that no water flows from the tank. At the end of the period, flush the water, carefully rub the inner surface of the toilet bowl with a brush. Repeat as necessary.

Oxalic acid and ammonia

The tool perfectly removes rusty stagnation on both enameled and faience toilets. Get oxalic acid solution in the household chemicals store, the concentration should be no less than 5-9%. Apply the composition in a clean form on the inner surface, carefully treating rust. Rub with a hard toothbrush or technical brush, leave for a quarter of an hour.

After the expiration, apply clear ammonia to the treated area, wait 10 minutes. Flush the toilet with a brush while flushing. As with cleaning agents, oxalic acid requires certain precautions. Be sure to wear gloves, goggles and a respirator (medical bandage).

Dishwasher Gel

Use a clean, non-diluted composition. Pour the product into the spray bottle. After that, rub the place of rust with ammonia and a brush, leave for 30 minutes, constantly update the mixture when it drains. After the expiration date, take a brush and a bottle of gel for dishwashers, spray the tool on the place with rust, rub it thoroughly for 10-15 minutes. Wash off, redistribute the gel, leave for 5 hours.

how to get rid of lime scale in the toilet

"Coca Cola"

On the Internet, a lot of clips, on which imported sodas, easily cope with rust, “walk”. The indisputable advantage of this method is that Coca-Cola can be poured directly into the toilet bowl, and not just to process the main zone.

To prepare the "yadron" mixture, it is necessary to dilute 100 gr. baking soda, 50 ml. table vinegar and 45 gr. citric acid in 400 ml. "Coca-Cola". Pour the composition into a convenient container with a neck, close the lid and shake a little. Bring the bottle to the toilet, open the lid and immediately treat the rust.Prepare in advance for the composition to foam.

Do not use the toilet for 6 hours, it is advisable to carry out the procedure in the evening to be able to leave the tool at night. As for the barrel, pour into it 2 liters of Coca-Cola mixed with 120 grams. citric acid, 45 ml. vinegar solution, 450 gr. baking soda. Leave on for 4-6 hours, then brush off.

Hydrochloric acid

To remove rust, you need a hydrochloric acid solution with a concentration of 33% and higher. Apply the composition under the bezel and on the places of formation of plaque, immediately close the lid of the toilet bowl and wait about half an hour. After that, drain the water, clean the surface with a brush and repeat the steps if the result was incomplete.

You can also use hydrochloric acid powder. In this case, the technology changes slightly. Take 50 gr. composition and pour to it 30 ml. warm filtered water. Fold the gauze or bandage in 10 layers, scoop the tool and carefully rub the rust. Wait at least 1 hour, rinse.

Protect your hands, eyes and respiratory tract before you work with acid. Hold the breath while applying the compound, if you are not working in a respirator. Do not breathe vapors of acid.The tool is suitable only for emergency cases, since with frequent use it destroys enamel.

how at home to clean the toilet from clogging

Car Battery Electrolyte

A great way to cope with rust in a quarter of an hour. The technology can only be used if the sewer pipes coming from the toilet bowl are not made of plastic. Take the liquid from the old battery or buy it in the car department (cost about 100 rubles). Pour the composition under the bezel and in place of rust, leave for 10 minutes, then rub the brush well (after that, throw it away). When working with electrolyte, you must wear gloves and glasses.

Vinegar

To remove rust, you will need to purchase acetic essence with a concentration of 70% or more. Do not confuse with ordinary table vinegar (9%), it will not cope with the ingrained residue. Take 110 gr. powder for washing machines, pour 150 ml to it. Acetic essence, do not wait for the dissolution of the granules. Immediately scoop the mixture onto a kitchen sponge and treat the areas of rust accumulation. Rub the surface well, rinse with water and repeat the procedure.After five thorough treatments, reapply and leave for 7 hours.

Chlorine-containing drugs

Shut off the riser, use the plunger to drain all the water from the toilet bowl. Pour 700 ml into it. bleach, leave for 4 hours. If the ability to drain water is missing, or you do not know how to do it, pour whiteness under the rim and rust, wait 6 hours or more. At the end of the action, do not rush to rinse, treat the rusty scurf with a brush or a hard sponge. As with other cleaning products, take precautions and do not breathe chlorine fumes.

Soda and tartaric acid

Means that you prepare, refers to the abrasive preparations. With frequent use, small particles will begin to erase the enamel, as a result of which the toilet becomes unusable. Keep this in mind. To cook a quality composition, take 45 grams. tartaric acid and pour it 85 ml. ammonia. After that add the amount of soda, so that the mixture does not get too dry.

When everything is ready, put on gloves, treat the place of rust with medical alcohol or vodka. Scoop a large amount of the composition on a kitchen sponge and rub well the place of rust for 10-15 minutes.After that, flush the water and repeat the steps, leaving the composition for 5 hours.

You can get rid of rust forever; it’s enough to use one of the suggested options. You should start with the purchase of acidic cleaners, give preference to drugs marked "Antirzhavchina." To prevent further tumors, throw a water-softening pill into the tank.

how to get rid of unpleasant smell in the toilet