How to make a glowing liquid from improvised means

Glowing in the dark water is a great way to make a party unusual and memorable. Also, the glowing liquid will cause a lot of positive emotions in children, who will gladly pour an unusual cocktail from one glass to another. But do not forget that the liquid flickering with all the lights is not a harmless water, but a chemical mixture. Observe the dosage and sequence of actions so that the final result brings joy, not additional efforts.

What is a glowing liquid

The basis of the luminous liquid is substances capable of reflecting light. In the case of luminous water, they should not be dissolved in water, otherwise there would not be a physicochemical reaction, and there would be no effect.The main active ingredient is an organic or inorganic compound, which, when interacting with an oxidizing agent (hydrogen peroxide), is capable of emitting a luminescent glow. The catalyst can serve as iron, phosphorus, in their presence the emitted luminescence differs in saturation and intensity.

Where is luminol used

Luminol is a crystal capable of glowing in the presence of iron and other metals. It is actively used in forensic examination for the detection of traces of blood. Luminol is also used in chemistry lessons, as well as electrical insulation.

How to get luminous liquid with luminol

How to make a glowing liquid with luminol

Luminol is a yellow powder, which in an alkaline medium begins to glow a bluish color.

1. Take 50 ml of luminol solution and transfer it to a glass flask, preferably one in which experiments are performed in chemical laboratories.
2. Add 40 ml of 3% hydrogen peroxide solution, mix.
3. Pour quite a bit, on the tip of the knife of copper sulfate (ferric chloride).
4. If no chemicals are found, drip a few drops of blood from the thawed beef or chicken liver.
5. Add to the same 5 ml of caustic soda.
6. Transfer the flask to the dark room and turn on a small lamp or light candles. The flask begins to flow with a fluorescent blue glow. To change the shade, add a few drops of another dye.

There is another way to get luminous water.It is suitable for those who do not keep at home chemicals like copper sulfate.

• dissolve in a glass of water a teaspoon of ordinary laundry detergent
• there also add 10 ml of hydrogen peroxide and 5 ml of luminol solution
• mix, add a little potassium permanganate
• under the influence of an alkaline medium, the liquid will begin to bubble and overflow with different colors

Do not forget that chemicals should be used very carefully. And also thoroughly wash the dishes after the experiment. And well, if only the dishes. Because if the technology is not followed, the unexpected may occur. In short, if you are not friends with chemistry, it is worth looking for ways to get luminous water easier.

Getting a glowing liquid with a color highlighter

1. Get a highlighter (do not confuse it with a marker, the marker has a more dense texture, highlighters are usually produced in neon shades).
2. Check the highlighter for the content of fluorescent paint (swipe over a sheet of paper, walk with it into a dark room and light up a little).
3. Remove the rod and cut it lengthwise. Put the contents in a glass of warm water.Wait until the color filler enters the water.
4. Add a little soda, then the liquid will bubble. Transfer the glass to the dark room and highlight.

Glowing water from coniferous concentrate

1. Take coniferous concentrate on the tip of the knife (it contains saline filler, fir essential oil, saline filler).
2. Pour a glass of water and pour in the concentrate from the needles. Type the floor a tablespoon of boric acid. Hold the spoon over the fire (turn on the burner, light the candle).
3. Slowly pour in a little coniferous solution, heat until boiling.
4. The resulting crystalline substance is called a phosphor, it gives ordinary water glow.

The phosphor can be used as a base for luminous paint. To do this, take a transparent nail polish weighing 7-8 grams and mix the contents with 2-3 grams of phosphor. To add shade, add a drop of regular fluorescent paint. Of course, the paint will not shine as brightly as the finished store paints. But its brightness is enough to produce the desired effect.

To create a luminous liquid with improvised means, you need to have at home at least at least luminol powder or “Galavita” tablets, which have the necessary components.With luminol, the glow will be much brighter and last longer. For greater safety, use safe materials like a rod from a marker or ordinary laundry detergent. Remember about safety measures, do not harm yourself.

Video: how to make a glowing liquid at home